AT-200
AUTOMATIC FERRITE CORE WIRES BONDING MACHINE


Continuously lead wires automatic cut, form and connected to the ferrite core.

High efficiency low noise.

Continuous produce increases productivity, replacing the old manual process.
   (150-200 PCs / per minute)

 Specification
 WIRE FEEDER
2 sets of wire feeder feed the wires from the rear side of machine.
The functions of wire feeder are feed the wire to next process as well as straighten the  wire to ensure the next process can be done properly.
 PARTS FEEDER
This feeder vibrates the ferrite cores to assembly drum one by one.
 GLUING MECHANISM
This mechanism includes one set of wire transfer drum and one set of gluing device.
Transfer drum transfers the wires from wire feeder to the gluing device.
Gluing device rolls up the glue and coats it on the end point of wire automatically.
 ASSEMBLYING MECHANISM
This mechanism includes one set of assembly drum and two sets of wire pushing device.
The ferrite cores are loading on the assembly drum, the wires with glue are sending to the both end of ferrite core  then  been pushing into the holes on the both ends of core precisely and automatically.
 HEATING DEVICE
4 pieces of air heater and one piece of electric heater are installed on the heating zone to ensure the bond is  completely dry.
 TURN TABLE OF BULK  PACKAGE
The bulk packing boxes can be loaded on the turn table.
The bonded cores will be dropped down into the boxes piece by piece.
The dropping quantity of each box can be calculated by counter, when the counting reach TJE preset number, the turn  table will index automatically and move the next box in loading position.